CNET CQU-906 Manuel d'utilisateur Page 1

CQU-906 Wireless-N Pico USB Dongle User Manual Ver 1.00

105. The wireless securities setting should be the same as the connected access point. You should check the encryption details of your connected acc

116. Once the wireless network connected successfully, you will see IP information in the page.

127. Go to “Profile” page to ensure the selected wireless access point has been added. In this page, you can also remove, edit, duplicate and set de

13Chapter 4. Wi-Fi Protected Setup (WPS) Wi-Fi Protect Setup (WPS) is an easy way to setup your wireless network security. Make sure your selected a

142. Click “Refresh” button to re-search WPS enabled access points nearby. Choose an access point you want to connect, the click “Select” 3. It

154. For example, our selected access point named CQR-980. Click into its setup pages to WiFi Protected Setup and key in the PIN code into Client P

16 4.2. Wi-Fi Protected Setup (WPS) 1. Click “Push Button (PBC)” button Note: You can push the physical ‘WPS’ button on USB adapter or the virtua

172. It will take few seconds to one minute for the CQU-906 establishes the connection with your selected access point. Your need to start the PBC f

18Chapter 5. Mode Selection 5.1. Access Point and Station mode selection Users can switch between Station and Access Point modes.

19 5.2. Access Point Mode Soft AP function is to enable your wireless adapter as a Virtual Wi-Fi Access Point to extend Wireless coverage and

2Table of Contents Chapter1. Introduction...31.1. Ab

20Chapter 6. Other function 6.1. Radio Off Enable the Radio Off will turn off the radio function. It means CQU-906 will turn off the

21 6.2. Disable Adapter Disable the CQU-906 adapter will turn off the USB adapter function. It means all functions of CQU-906 will be turn off.

22Chapter 7. Uninstalling Wireless Utility 1. Go to start menu and then select “Programs” or “All Programs”. Find a folder “CNet” and click “Uninst

23

24Appendix 1. Troubleshooting PROBLEM CORRECTIVE ACTION None of the LEDs turn on when I plug in the wireless USB adapter. Make sure you have tur

25 Appendix 2. Planning Your Wireless Network A2-1 Network Topology A wireless local area network (WLAN) is exactly like a regular local area netwo

3Chapter 1. Introduction 1.1. About CQU-906 Thank you for choosing CQU-906 Wireless-N Pico USB Dongle. CQU-906 is a new generation super mini, lo

4Chapter 2. Installing the Software of the USB adapter Notes: Driver installation process of Windows 2000/2003/Vista/7 is similar to Windows XP Bef

52. Please click “Next”. 3. Click “Install” to start the setup program or click “Cancel” to abort the installation process.

64. Please wait for few minutes when running installation 5. Restart your computer to make the installation completed. Select “Yes, I want to

7Chapter 3. Configuring Your Wireless Network 1. Double click on the green wireless signal icon in your taskbar or the shortcut icon on the d

83. Go to the “Available Network” page, and click “Refresh” if your preferred wireless access point is not shown here. After the Scan results disp

9 4. The wireless Network Properties window will pop up. If the access point you selected enables encryption (WEP, WPA, WPA2, and etc…), please s